Woolwell Centre roof

Bickleigh Paish Council is looking to achieve Net Zero Carbon in Operational status for their key asset, namely the Woolwell Community Centre. The intention therefore is to cover all the electricity usage by the generation and offset of the carbon emissions for the gas usage during the year via PV Arrays (solar). These PV Arrays will be installed on the existing flat roof areas of the building. It is currently anticipated that the arrays will be ballast mounted and not "A" frame mounted. Prior to undertaking this PV Array work, there are two key flat roof sections on the building which will require remedial works, one circa 380m2 and a smaller roof located at a slightly lower level, covering circa 105m2. • It will be necessary to either remove in its entirety the existing protective coverings and replace with new or • Re-cover (overlay), the existing flat roof protective coverings with new after scraping clean all existing protective covering, cutting and releasing any blisters, patch covering any splits, then applying an enhanced bond liquid primer (or similar NFRC approved application) for receipt of new protective covering. Either of these options may require the potential rectification of any existing defective structural decking, insulation and/or vapour barriers as deemed necessary. The square metreage values quoted for the roof areas are only to serve as a guide and not a specification. Therefore, Bidders must satisfy themselves with regards to the exact square metreage by on-site surveys.